Table of Contents
Advertisement
12
Installing the Light Switch and
the Horn Button
Parts needed for this procedure:
1
Horn switch
1
Button cover
1
3-position switch
1
Light-switch decal (plain)
Installing the Horn Switch
1. Remove the knob from the differential-lock rod
45).
2. Remove the 4 hex-head screws (1/4 x 1/2 inch) as
shown in
Figure
45.
Figure 45
1. Knob
3. Lift the control-panel cover and the choke control
(Figure
46).
(Figure
2. Hex-head screw (1/4 x 1/2
inch)
1. Control-panel cover
4. Remove the round plug from the control-panel cover
(A of
Figure
47).
1. Panel plug (round)
2. Control-panel cover
3. Jam-nut (horn switch)
5. Assemble the horn switch to the control-panel cover
with the jam nut, and tighten the jam nut by hand (B of
Figure
47).
6. Assemble the button cover onto the horn switch (C of
Figure
47).
7. Connect the 2-pin socket of the kit harness to the
2-blade connector of the horn switch
19
Figure 46
2. Choke control
Figure 47
4. Horn switch
5. Button cover
(Figure
48).
Advertisement
Table of Contents
