Table of Contents
Advertisement
Figure 37
1. Wire harness
2. Boom-valve bracket
4. Route the wire harness to the left of the flow meter and
toward the boom-frame channel
Figure 38
1. 4-socket connector (
LEFT
/
REAR TURN
BRAKE SIGNAL
2. Bullet connectors (
LICENSE
)
LIGHT
5. Route the 2 bullet connectors labeled
through the 25 mm (1 inch) hole in the license-plate
bracket
(Figure
38).
6. Connect the 4-socket connector of the wire harness to
the 4-pin connector of the tail-light lead
3. 4-socket connector (
/
REAR TURN
BRAKE SIGNAL
(Figure
38).
3. 4-socket connector (
)
/
REAR TURN
BRAKE SIGNAL
LICENSE LIGHT
(Figure
1. Tail light
2. 4-socket connector
7. Repeat step
10
LEFT
)
Installing the License-Plate
Light
Parts needed for this procedure:
1
License-plate light
1
Screw (#10 x 5/8 inch)
2
Locknut (#10)
Procedure
1. Insert the 2 bullet connectors labeled
into the 2 sockets of the license-plate light
RIGHT
)
39).
1. License-plate light
2. Socket
17
Figure 39
3. 4-pin connector
6
for the other tail light.
Figure 40
3. Bullet connector (labeled
LICENSE LIGHT
LICENSE LIGHT
(Figure
40).
)
Advertisement
Table of Contents
