Toro 41250 Installation Instructions Manual page 14

Routing the Wire Harness to the Side
Console
1. Route the harness through the front of the seat shroud
(Figure 25).
Figure 25
1. Opening in the front of the seat shroud
2. Route the harness to the side console
Figure 26
1. Harness
Routing the Wire Harness to the Battery
1. Route the harness to the left from the side console to
the flasher module.
2. Route the harness leg with the ring terminal to the
positive post of the battery
Note: Connect the harness leg with the ring terminal
to the positive post of the battery just before installing
the seat shroud and seat.
(Figure 26).
(Figure 27).
1. Ring terminal
Routing the Wire Harness to the
Turn-Signal
1. Remove the 2 bolts that secure the hose cover to the
machine and remove the hose cover
1. Hose cover
2. Route the wire harness forward and along the hoses
toward the headlights, the turn-signal switch, and the
horn.
3. Connect the leg of the wire harness with the 8-socket
connector to the 8-pin connector of the turn-signal
switch (Figure 29).
14
Figure 27
2. Positive (+) battery post
(Figure 28).
Figure 28
2. Bolts