Advertisement
Figure 3
1. Setscrew (8 x 25 mm), 2
2. Control-box bracket
11. Fasten the electric control box to the bracket using 4
self-tapping screws (6 x 12 mm).
Figure 4
1. Electric control box
12. Take the umbilical cable assembly and identify the end
with 2 control box connectors. Pass this end of the
cable through the keyhole-shaped hole at the front of
the bracket and secure it with the back nuts provided.
g025356
3. Washer (8 mm), 4
4. Locknut (8 mm), 2
g025357
2. Self-tapping screw (6 x 12
mm), 4
1. Umbilical cable assembly
13. Connect the 2 umbilical cable plugs to the electric
control box, using the large cable tie provided.
14. Assemble the lift-control block assembly with the
fittings as shown in
5
1. Bonded seal (1/4 inch)
2. Adapter (1/4 inch male x
1/4 inch male)
3. Plug (1/4 inch male)
4. Plug (3/8 inch male)
5
Figure 5
Figure 6
and
Figure
7.
4
5
4
1
3
Figure 6
5. Bonded seal (3/8 inch)
6. Adapter (3/8 inch male x
3/8 inch male)
7. Lift manifold
g025358
1
2
G025630
g025630
Advertisement
