Advertisement
3
Installing the Remote Control
Box and Brackets
Parts needed for this procedure:
1
Remote-control box
2
Remote-control bracket
4
Cap screw (8 x 25 mm)
8
Washer (8 mm)
4
Nut (8 mm)
4
Locknut (8 mm)
Procedure
1. Remove and discard the control levers and the bracket.
2. Mount 1 remote-control bracket on the machine, as
shown.
Figure 17
1. Nut (8 mm), 2
2. Washer (8 mm), 4
3. Cap screw (8 x 25 mm), 2
4. Remote-control bracket
3. Mount the other bracket in a suitable location in the
cab of the tractor.
Important: Refer to the information from
the tractor manufacturer so that the bracket
installation does not compromise the safety of the
ROPS.
1
2
3
5. Locknut (8 mm), 2
6. Umbilical cable assembly
7. Remote-control box
8. Power cable
4. Connect the power cable into the 12-volt socket in the
cab of the tractor.
G025406
g025406
10
Advertisement
