Advertisement
Figure 19
1. Transport
latch—automatic latching
position
4. Start the tractor and set the engine speed to a slow idle.
5. Engage the rear PTO drive of the tractor.
Stop operating the machine as follows:
1. Locate the override lift control switch on the control
pad
(Figure
18), and pull it back until all the cutting
units are raised to the transport position.
2. Release the switch, and engage all of the transport
latches.
3. Disengage the rear PTO drive of the tractor, and stop
the engine.
4. Push the override control switch, and move the
individual lift switches to the Drop position.
Note: This fully engages the arms into the transport
latches.
5. Engage all the transport latch safety locks as shown
in
Figure
20.
Figure 20
1. Safety lock—engaged
6. Latch the outer cutting units
g026019
2. Safety lock—flipped up
g026020
(Figure
21).
1. Outer cutting unit latch
13
Figure 21
g026021
Advertisement
