Table of Contents
Advertisement
FusionModule1000A20 Prefabricated All-in-One Data
Center
Maintenance Guide
Figure 4-15 Removing a camera
Step 2 Use a Phillips screwdriver to remove the screws that fasten the camera to its base.
Step 3 Remove the network cable and take out the camera.
Step 4 Install the new camera by following instructions in documents delivered with the camera,
tighten the screws to secure the camera to the base, and reconnect the network cable in the
original way.
Step 5 Adjust the angle of the camera to cover the monitored area by following instructions in
documents delivered with the camera.
Step 6 Configure the camera by referring to the management system initial configuration table.
Step 7 Check that the new camera is working properly.
----End
4.3.6 Replacing Access Control Components
4.3.6.1 Replacing an IC Card Reader
Prerequisites
A spare IC card reader of the same model is available and functional.
Impact on the System
None
Preparations
Tools: Phillips screwdriver, protective gloves
Materials: access card, spare IC card reader
Skill requirement: ELV engineer
Issue 01 (2019-07-15)
The original parameter settings can be used.
Copyright © Huawei Technologies Co., Ltd.
4 Parts Replacement
47
Advertisement
Table of Contents
