Huawei IPE Series Installation Manual page 9

IPE
Installation Guide



Important Notice








Cleaning Tips



Environment Requirements




Issue 03 (2013-02-28)
Before installation is complete, do not power on the IPC. Before inserting or removing
cables to or from the IPC, stop using the IPC and cut off the power supply of the IPC.
Check whether the power supply is correct before the IPC is put into use.
Ensure that the power sockets are clean and moisture-free to prevent an electric shock or
other dangers.
Prevent the product from being damaged by the heavy weight, serious shock, or water
immersion during transportation, warehousing, and installation of the product. The
warranty does not cover the damage resulting from improper transportation of an
assembled product no matter whether the product is delivered by the contractor or is
returned to the factory for service.
Do not install the IPC upside down. Handle the module with care. Do not squeeze the
mechanical part. Otherwise, mechanical faults may be resulted.
Do not disassemble the IPC without prior approval. The module does not contain any
part that users can repair by themselves. The IPC must be sent to the professional
maintenance personnel for service.
Do not scratch or wear out the housing of the IPC. Otherwise, the paint that falls off may
cause allergy or an IPC fault. For example, the paint may fall into the module and causes
a short circuit.
If an abnormal symptom is detected, for example, smoke comes out of the IPC, the IPC
generates an abnormal sound or smell, stop using the IPC, cut off the power supply, and
remove all cables (including power and network cables) from the IPC.
When the IPC is faulty, send the IPC to the designated maintenance center for service.
Deploy surge protection devices if the device is installed outside.
When working at heights, use a safe elevator and secure the safety belt, and take
necessary security measures.
Before cleaning the IPC, stop using the IPC, cut off the power supply, and remove all
cables (including power and network cables) from the IPC.
Use soft and dry cloth to wipe the IPC. To remove stubborn stains, dip a clean and soft
cloth with appropriate neutral detergent and then use the cloth to wipe and dry the IPC.
Do not use volatile solvent (such as alcohol, benzene, or thinner) or alkaline detergent
containing the abrasive to clean the IPC. Otherwise, the coater of the IPC will be
damaged or the operating performance of the IPC will be deteriorated.
Protect the IPC against penetration of water or other liquids. If the liquid accidentally
enters the IPC, immediately cut off the power supply and remove all cables (including
power and network cables) from the IPC.
Prevent the product from being damaged by the heavy weight, serious shock, or water
immersion during transportation, warehousing, and installation of the product.
Keep the IPC far away from a heat source or exposed ignition source, such as the electric
heater and candle.
Do not install or use the IPC in the areas with highly flammable or explosive objects.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
1 Installat ion Precautions
2