Huawei IPE Series Installation Manual page 56

IPE
Installation Guide
Step 7 Rotate the module clockwise for about five degrees to install the module inside the lower
cover. Use a Philips screwdriver to fasten three black screws that are previously removed in
Step 2, as shown in Figure 6-6. (Spare screws are available in the accessory kit.)
Figure 6-6 Fastening screws
Step 8 Connect the video cable to the second video port. Check the video, adjust the lens angle, focus,
and viewing angle in the horizontal and vertical directions, and insert the SD card, as shown
in Figure 6-7.
Issue 03 (2013-02-28)
NOTE

If the side cabling mode is used, route the multi-connector cable through the side cable outlet of the
lower cover.

If the top cabling mode is used, route the multi-connector cable through the cable outlet on the top.
Top cabling
Side cabling
Multi-connector cable
NOTE
If the module is found loose after the video adjustment is complete, use a flat-head screwdriver to fasten
the screws on the module again.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
6 Installing an Infrared Do me IPC
Three black screws
49