Prt Assignment - NEC UNIVERGE SV9300 Networking Manual

PRT ASSIGNMENT

START
CM05 Assign a Unit number and Slot number to the
PRT blade.
Assign the Trunk Blade number to the PRT
blade.
Assign the number of Highway Channels for
ISDN data communication.
NOTE 1:
NOTE 2:
CMAA Specify the type of PRT blade.
A
DESCRIPTION
BLADE RESET
BLADE RESET
When the second data of this com-
mand is set to NONE (No data), the
PRT blade for ISDN data communi-
cation must be accommodated to the
base slot (Slot No. 01/07/13) of each
line trunk module. In this case, the
available Highway Channels for
data communication are the only
first 16 channels.
When this command is set,
additional chassis time slots are
used.
Example: CM05 Y=2>0101: 12 will
use 12 chassis time slots.
• Y=0
(1) XX ZZ
XX: 01-50: Unit No.
ZZ : 01-18: Slot No.
(2) 45: PRT blade for Q-SIG
• Y=1
(1) XX ZZ
XX: 01-50: Unit No.
ZZ : 01-18: Slot No.
(2) 000-127: Trunk Blade No.
• Y=2
(1) XX ZZ
XX: 01-50: Unit No.
RESET
ZZ : 01-03: Line/Trunk chassis No.
(2) 01-16: Number of Highway Channels for
• Y=15
(1) 000-127: Trunk Blade No. assigned by
(2) 0 : E1 (2 Mbps)
1 : T1 (1.5 Mbps)
2-12
Chapter 2 Q-SIG FEATURES
PRT ASSIGNMENT
DATA
ISDN data communication
CM05 Y=1
NWA-088654-001 Rev.1.0
94ch2001.fm