Mitsubishi Electric MELSEC iQ-R Series User Manual page 31

Devices that can be specified as triggers
The following table shows the devices that can be specified as triggers.
*1
Device name (device)
User device Input (X)
Output (Y)
Internal relay (M)
Link relay (B)
Annunciator (F)
Link special relay (SB)
Edge relay (V)
Timer (T)
Retentive timer (ST)
Long timer (LT)
Long retentive timer (LST)
Counter (C)
Long counter (LC)
Data register (D)
Link register (W)
Link special register (SW)
Latch relay (L)
System device Special relay (SM)
Special register (SD)
File register (R)
(ZR)
Refresh data register (RD)
*1 Digit-specified or indirect-specified bit devices and index-modified devices cannot be specified.
Precautions
When specifying a file register (R/ZR), do not change the file name or block number of a file register after the recording
function starts running. Otherwise, the recording function may not run normally and a recording result may not be reproduced
properly.
Remarks
DXs cannot be specified.
DYs cannot be specified.
Local devices cannot be specified.



Local devices cannot be specified.
• A contact (TS) is a target.
• Local devices cannot be specified.
• A contact (STS) is a target.
• Local devices cannot be specified.
• A contact (LTS) is a target.
• Local devices cannot be specified.
• A contact (LSTS) is a target.
• Local devices cannot be specified.
• A contact (CS) is a target.
• Local devices cannot be specified.
• A contact (LCS) is a target.
• Local devices cannot be specified.
• Specify a word device as a bit (example: D0.0).
• Local devices cannot be specified.
Specify a word device as a bit (example: W0.0).
Specify a word device as a bit (example: SW0.0).


Specify a word device as a bit (example: SD0.0).
Specify a word device as a bit (example: R0.0).
Specify a word device as a bit (example: RD0.0).
1 FUNCTIONS
29
1.1 Recording Function
1