Table of Contents
Advertisement
B
Connection with the VCR
Connect an audio/S-video cable between the
playback VCR's audio/S-video output connectors
and the recording VCR's [AUDIO/S VIDEO IN]
connectors.
● When using this VCR as the recording VCR,
connect this VCR's [AUDIO/S VIDEO IN]
connectors to the audio/S-video output
connectors on the other VCR.
If the playback VCR is monaural, connect the
audio output connector on the playback VCR to
the [AUDIO-L IN] connector on this VCR.
NOTE:
If another VCR does not have S-video input/output
connectors, use a video cable.
2
Load a cassette
Insert the cassette to be recorded on into this VCR
(for recording).
3
Select input location on this VCR
[L-1] or [L-2] — when connecting the device to
the [AUDIO/VIDEO IN] or
[AUDIO/S VIDEO IN]
connectors on the rear panel.
[F-1]
— when connecting the device to
the [AUDIO/VIDEO IN] or
[AUDIO/S VIDEO IN]
connectors on the front panel.
On the front panel:
Press [CHANNEL +/–].
On the Remote:
Press the 'Number' key [0 (AUX)] or
[TV/VCR CH +/–].
NOTE:
When using this VCR as the recording VCR, set the
video input terminal setting correctly (
4
Set recording speed
Press [REC SPEED] to set the tape speed.
Input Source
Selectable Recording Speed
(Playback device)
(Recording device: This VCR)
Analog
S-VHS/VHS
input
5
6
7
8
NOTES:
● Be sure to select "AUTO" for "PICTURE CONTROL" (or
"NORM" when "VIDEO CALIBRATION" is set to "OFF") after
you finish dubbing the tapes (
● It is impossible to perform dubbing properly only with an
audio cable. Connect also the video or S-video cable.
pg. 38).
SP, EP
Select video input terminal
Access the "FUNCTION" screen (
When using [S VIDEO] terminal, set "FRONT
AUX F-1" (or "REAR AUX L-1" (or "L-2") if you
use the connectors on the rear) to "S-VIDEO".
When using [VIDEO] terminal, set "FRONT AUX
F-1" (or "REAR AUX L-1" (or "L-2") if you use the
connectors on the rear) to "VIDEO".
Set "PICTURE CONTROL" to "EDIT"
Access the "FUNCTION" screen (
Start playback
Press [PLAY ( 3 )] on the connected device.
NOTE:
If the connected device is equipped with a
superimpose/OSD disable feature then set it to "OFF"
before starting playback.
Start recording
On the front panel:
Press [REC ( ¶ )].
On the Remote:
Press [REC ( ¶ )] and [PLAY ( 3 )] at the same
time.
pg. 36).
45
EN
pg. 38).
pg. 36).
Advertisement
Table of Contents
