JVC HM-DB1U Instructions Manual page 43

1
Make connections
A Connection with the camcorder
Connect an i.LINK cable between the
camcorder's i.LINK input/output connector and
your VCR's [i.LINK IN/OUT] connector.
Connection with the VCR
B
Connect an i.LINK cable between the playback
VCR's i.LINK input/output connector and the
recording VCR's [i.LINK IN/OUT] connector.
NOTES:
● Depending on the devices equipped with the i.LINK
connector which is connected to the VCR, picture
noise on this VCR may differ from the noise on the
connected devices. It is caused by the difference of
the data processing method.
● Connection with certain product(s) may not be
supported. ( 'ATTENTION' on the back cover.)
2
Load a D-VHS cassette
Insert the cassette to be recorded on into this VCR
(for recording).
3
Select input location on this VCR
On the front panel:
Press [CHANNEL +/–] to select "I-1" etc.
On the Remote:
Press [TV/VCR CH +/–] to select "I-1" etc.
4
Set recording speed
Press [REC SPEED] to set the recording speed.
● For more details, refer to 'About Recording
Speed' below.
About Recording Speed
Input Source
(Playback device)
D-VHS
i.Link input
Others
* Auto mode: The recording speed will be selected automatically according to the amount of data input (the transfer rate) from
the i.LINK connector.
NOTES:
● When dubbing using the i.LINK connector, set the recording speed on the recording VCR to the same speed as the source tape
on the playback VCR.
● When "AUTO" is selected for the recording speed, "AUTO" and the selected speed appear on the front display panel in turn.
● When dubbing using this VCR as the recording device, if the tape speed of the playback device is in LS3 or LS5 mode, setting
the recording speed of this VCR to "AUTO" enables recording. But recording will be in STD mode.
Selectable Recording Speed
(Recording device: This VCR)
Auto (HS/STD)*, HS, STD
Auto (HS/STD)*, HS
5
Start playback
Press [PLAY ( 3 )] on the connected device.
NOTE:
If the connected device is equipped with a
superimpose/OSD disable feature then set it to "OFF"
before starting playback.
6
Start recording
On the front panel:
Press [REC ( ¶ )].
On the Remote:
Press [REC ( ¶ )] and [PLAY ( 3 )] at the same
time.
NOTE:
If "108" appears on the TV screen, refer to 'Error Codes' on page
53.
Do not connect this VCR to the PC with the i.LINK
cable. The operation is not guaranteed.
43
EN