Table of Contents
Advertisement
34
EN
ATTENTION
● If there is a conflict in the timer schedule and one
program overlaps with another, only the parts shown
below in gray will be recorded.
Pattern 1: The program with the lower program number
will be recorded.
10:00
11:00
Program 1
CH10
CH40
Program 2
Pattern 2: The program starting earlier will be recorded.
10:00
11:00
Program 1
CH40
Program 2
Pattern 3: The program starting earlier will be recorded,
followed by the remaining portion of the
other program.
10:00
11:00
CH10
Program 1
Program 2
● When using i.LINK Timer Programming or Video Remote
Control Timer Programming, if the program stop time of
the Integrated HDTV (or Digital Set Top Box) coincides
with the program start time of the VCR or vice versa,
only the parts shown below in gray will be recorded.
10:00
11:00
Integrated HDTV
Program 1
Program 2
10:00
11:00
Program 1
Program 2
This VCR
NOTES:
● During timer programming, try to set an interval of
more than 1 minute between the program stop time of
Program 1 and the program start time of Program 2 or
vice versa.
● For the timer programming method, refer to the
manual of the Integrated HDTV.
12:00
Not recorded
12:00
Not recorded
12:00
CH40
Not recorded
This VCR
Not recorded
Integrated HDTV
Not recorded
TIMER RECORDING (cont.)
Other Useful functions for timer recording
You can also use the following functions for timer
recording.
● "AUTO TIMER" (
pg. 37)
When "AUTO TIMER" is set to "ON", the timer recording
standby mode is automatically engaged when the VCR is
turned off. It is temporarily canceled when the VCR is
turned on. You do not have to press [TIMER (‰)] to engage
or disengage the timer recording standby mode.
● "AUTO SP = EP TIMER" (S-VHS/VHS only) (
If there is not enough tape to record the entire broadcast
for recording in SP mode, the VCR automatically switches
to EP mode to allow complete recording. This feature is
especially handy when recording a broadcast of more than
2 hours in length.
pg. 37)
Advertisement
Table of Contents
