1. Air filter case
2. Air cut-off valve
3. Air induction system hose (air filter case to air cut-off
valve)
4. Cylinder head cover
5. Air induction system hose (air cut-off valve to reed
valve cover)
6. Cylinder identification sensor
7. Cylinder identification sensor lead
A. Point the end of the clamp to the right. Install the air
induction system hose (air filter case to air cut-off
valve) with its white paint mark facing outward. Make
sure that the clamp is not installed on the flange of the
hose fitting of the air filter case.
When installing the air induction system hose (air
filter case to air cut-off valve), may apply water to the
air induction system hose.
B. Point the end of the clamp to the left.
C. Point the end of the clamp upward.
D. Insert the air induction system hose (air cut-off valve
to reed valve cover) until it contacts the reed valve
cover. Make sure that the clamp is not installed on the
flange of the hose fitting of the reed valve cover.
E. Point the end of the clamp to the right.
2-54
CABLE ROUTING