Yamaha YZF-R1 Series Service Manual page 81
Hide thumbs
Also See for YZF-R1 Series:
- Owner's manual (130 pages) ,
- Service manual (92 pages) ,
- Manual (82 pages)
Table of Contents
Advertisement
1. Brake hose (front brake master cylinder to
hydraulic unit)
2. Brake hose (hydraulic unit to front brake calipers)
3. Front wheel sensor lead
4. Front brake caliper
5. Front wheel sensor
6. Front fork leg
7. Collar
8. Front brake master cylinder
9. Front wheel sensor protector
A. Point the open ends of the holder forward.
B. Fasten the front wheel sensor lead to the brake
hose (hydraulic unit to front brake calipers) with the
holder. Position the holder above the flange on the
brake hose (hydraulic unit to front brake calipers).
Route the front wheel sensor lead to the inside of
the brake hose (hydraulic unit to front brake
calipers).
C. Route the front wheel sensor lead along the left
hose of the brake hose (hydraulic unit to front
brake calipers) without any slack.
D. Route the front wheel sensor lead to the inside of
the brake hose (hydraulic unit to front brake
calipers).
E. Fasten the front wheel sensor lead at the white
tape with the holder.
F. Install the holder on the shrink-tubing portion of the
brake hose (hydraulic unit to front brake calipers).
G. Install the collar so that the edge of the collar is
positioned 1–2 mm (0.04–0.08 in) from the end of
the projection.
°
H. 90
I.
Install the collar so that its slit is positioned within
the range shown in the illustration.
J. For YZF-R1M
K. Route the front wheel sensor lead through the
guide on the front wheel sensor protector.
L. Fasten the brake hose (front brake master cylinder
to hydraulic unit) at the shrink-tubing portion of the
hose to the outer tube with a plastic locking tie.
Position the plastic locking tie below the flange on
the brake hose (front brake master cylinder to
hydraulic unit).
M. Rearward
N. Position the buckle of the plastic locking tie 10 mm
(0.39 in) or more from the brake hose (front brake
master cylinder to hydraulic unit).
O. Forward
P. Cut off the excess end of the plastic locking tie to 5
mm (0.2 in) or less. The end of the plastic locking
tie may be pointing in any direction.
2-42
CABLE ROUTING
Advertisement
Chapters
Table of Contents
