Yamaha YZF-R1 Series Service Manual page 69

1. Steering damper solenoid coupler (Öhlins:
OPTION)
2. Steering damper solenoid coupler
3. Intake solenoid lead
4. Front turn signal/position light lead (right)
5. Sub-wire harness (front fork stepping motor)
6. Sub-wire harness (SCU, steering damper
solenoid, sub-wire harness)
7. Meter assembly coupler
8. Intake solenoid vacuum hose
9. Auxiliary light lead
10. Front turn signal/position light lead (left)
11. Wire harness
12. SCU (Suspension Control Unit)
13. Steering damper solenoid lead
A. The steering damper solenoid coupler (Öhlins:
OPTION) may be positioned in any place.
B. Route the front turn signal/position light lead (right)
under the intake solenoid lead, steering damper
solenoid lead, and sub-wire harness (front fork
stepping motor).
C. Connect the sub-wire harness (front fork stepping
motor) to the sub-wire harness (SCU, steering
damper solenoid, sub-wire harness).
D. To front turn signal/position light (left)
E. Connect the sub-wire harness (SCU, steering
damper solenoid, sub-wire harness) to the wire
harness.
F. After connecting the SCU coupler, install the
rubber cover completely until it contacts the SCU
(Suspension Control Unit). Make sure that the
edges of the coupler cover are not rolled up.
G. To front turn signal/position light (right)
H. Route the sub-wire harness (SCU, steering
damper solenoid, sub-wire harness) over the
intake solenoid vacuum hose.
I. To intake solenoid
2-30
CABLE ROUTING