In The Case Of Programming Tool (Version) Not Applicable; Program Transfer Speed And Programming Tools - Mitsubishi Electric MELSEC-F FX3G Series User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
5.2.2

In the case of programming tool (version) not applicable

Inapplicable programming tools can be used by selecting an alternative PLC model.
1. Alternative model setting
Model to be programmed
FX 3G PLC
*1. "FX " is selected when the FX-10P(-E) is used.
2N
2. Contents of restrictions
• Programming is enabled only for the range of functionality available in the PLC selected as the alternative
model, such as instructions, device ranges and program sizes. When the FX-10P(-E) is used, the range of
functionality is limited to that available in the FX
• Use a programming tool that can select either FX
register capacity, etc.
• The built-in USB port cannot be used for programming communication.
5.2.3

Program transfer speed and programming tools

1. Built-in USB communication
The FX PLC has a built-in USB communication port, and performs program writing, program reading and
3G
monitoring at high speed (12 Mbps) with a personal computer that supports USB.
1) Supported programming tools
GX Works2 (Ver. 1.08J or later), GX Developer (Ver. 8.72A or later)
2) In programming tools not supporting USB
Communication is performed via RS-422 or RS-232C.
2. RS-422/RS-232C communication
The FX PLC can write and read programs and perform monitoring at 115.2 kbps through RS-422/RS-232C
3G
communication.
1) 115.2 kbps supported programming tools
GX Works2 (Ver. 1.08J or later), GX Developer (Ver. 8.72A or later), FX-30P (Ver. 1.00 or later)
2) 115.2 kbps supported interfaces
- Standard built-in port (RS-422) or expansion board FX
When the RS-232C/RS-422 converter FX-232AWC-H is connected.
- Expansion board FX
- Special adapter FX
3) In programming tools not supporting 115.2 kbps
Communication is executed at 9,600 or 19,200 bps.
5 Version Information and Peripheral Equipment Connectability
Model to be set
FX 3G
2N
-232-BD for RS-232C
3G
-232ADP(-MB) for RS-232C
3U
5.2 Programming Tool Applicability
*1
FX FX
1N 2N
PLC.
to change parameters, i.e. memory capacity, file
3G
-422-BD for RS-422
3G
Priority High Low
*1
FX 2
59
1
2
3
4
5
6
7
8
9
10