Use Of (Built-In Usb) Programming Port; Installation Of Usb Driver; Setting In Gx Developer - Mitsubishi Electric MELSEC-F FX3G Series User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
5.3

Use of (Built-in USB) Programming Port

Make sure to set the contents described in this section when executing circuit monitor, device registration
monitor, program reading/writing, etc. in the FX
Works2, GX Developer Ver. 8.72A or later. For GX Developer is prior to Ver. 8.72A, communication using the
(built-in USB) programming port is not available.
5.3.1

Installation of USB driver

It is necessary to install the USB driver to execute USB communication using the (built-in USB) programming
port.
For the USB driver installation method and procedure, refer to the following manual.
5.3.2

Setting in GX Developer

1. Select [Online]
2. Double-click [Serial USB] in [PC side I/F] to open the "PC side I/F Serial setting" dialog box.
3. Select "USB (Built-in port)".
4. Click the [OK] button to finish the setting.
[Transfer setup...] to open the "Transfer setup" dialog box.
Double-click it.
5 Version Information and Peripheral Equipment Connectability
5.3 Use of (Built-in USB) Programming Port
PLC using the (built-in USB) programming port and GX
3G
→ GX Works2 Version 1 Operating Manual (Common)
→ GX Developer Version 8 Operating Manual (Startup)
Select "USB (Built-in port)"
1
2
3
4
5
6
7
8
9
10
63