Parameter Settings On The Regulators (Regulation Param); Regulators - GE AV-300i User Manual

1.4 PARAMETER SETTINGS ON THE REGULATORS (REGULATION PARAM)

1.4.1 Regulators

According to the chosen regulation mode, some control loops could be inactive.
The following table states (with X) which are the active loops corresponding to each different mode:
Mode
V/f
Sensorless (SLS)
Field Oriented (FOC)
* A pseudo-regulator, that is a circuit allowing some of the regulator protective functions, is active for
the current loop with a V/f mode..
As for the manual tuning of the different loops, if required, see section 1.4.5 – MANUAL TUNINGS.
The settings of the percentage gains are carried out according to the Basic value stated inside the specific menu.
Description:
REGULATION PARAM
Spd regulator
Percent values
SpdP1 gain %
SpdI1 gain %
Base values
SpdP base value
SpdI base value
In use values
InUse SpdP gain%
InUse SpdI gain%
SpdReg autotune
>> Test torque ref <<
Start ?
Waiting start...
Results
>> Measured Inertia <<
>> Measured Frict
AV-300i Version 2 User's Guide
Speed loop (Spd) Current loop (Curr)
*
X X
X X
Speed loop
percentage values:
Gain of the Proportional section as a percentage of the basic value
Gain of the Integral section as a percentage of the basic value
basic values:
Basic value of the Proportional gain
Basic value of the Integral gain
In use values:
In use value of the Proportional gain. It shows the active
gain in case a setting of the gain adaptive curve is required.
In use value of the Integral gain.
Speed loop self-tuning >>active with a FOC and SLS mode<<
torque reference applicable during the self-tuning procedure [Nm]
enabling of the data detection phase
waiting time during the procedure
Detected value
value of the measured inertia [Kg * m2]
value of the measured friction [Nm]
<<
—————— Function Description ——————
Flux loop (Flx) Speed loop
X X
X X
(Vlt)
TAV3 i0 0 5
Ch.1
45