GE AV-300i User Manual page 34

In the table are showed the values of IS ctrl src from SBI word, DGFC word or Int IS ctrl if:
IS ctrl src = Int IS ctrl.
No. bit Name
0-1 -
2 POLNLT
3 -
4-5 ENNQUAL
6 Target Enc Num
7 -
8-9 ENNLT
For the Index storing function, the control Registers are not available via the keypad and are to be used for
the configuration and the data reading. These are:
L index register Ipa 9556
H index register Ipa 9555
In the table are showed the registers values:
Ipa No. bit
0 Source Enc Num
1 MP_IN
9556
2-3 STATNLT
9555 0-15 CNTNLT
Ch.1
34
Description
Not used
It indicates the encoder index edge polarity:
0= rising edge
1= falling edge
Not used
It sets the qualifier input state to activate the encoder index reading:
=0, switched off when dig.input 7 = 0
=1, switched off when dig.input 7 = 1
=2, through signal = 0
=3, through signal = 1
It points out for whitch encoder the values of this parameter are reported:
=0, operations requested on the Std Encoder input
=1, operations requested on the Exp Encoder input
Not used
Control function of the encoder inedx reading
=0, swtched off, function disabled
=1, once, enables the reading of the first index signal edge only.
=2, continuous, enables the reading of the index signal
Name
It indicates to which encoder is used for index storing:
=0, register data are referred to the Std Encoder input
=1, register data are referred to the Exp Encoder input
Actual Qualifier input value (digital input 7):
=0, qualifier input level is low
=1, qualifier input level is high
Status of the acquisition function; as:
0=OFF
1=Once, storing is not executed yet
2=Once, storing is already executed
3=Continuous
Position counter value corresponding to the index.
Value is only valid when STANLT is equal to 2 or 3
—————— Function Description ——————
GEH-6641E
Description
Access (Read/ Write) Default
- -
R/W 0
- -
W 0
R/W 0
- -
R/W 0
TAV13241
Access
(Read/
Default
Write)
R 0
R 0
R 0
R 0
indexstorpar