GE AV-300i User Manual page 32

Std enc supply
Std sin enc Vp
Exp enc type
Exp enc pulses
Rep/Sim encoder
Index storing
Save config ?
Encoders config
Speed feedback
Std enc type
Std enc pulses
Std dig enc mode measuring method of the digital encoder speed connected to the
Std enc supply
Std sin enc Vp
Exp enc type
Ch.1
32
GEH-6641E
Encoder input selection:
Int spd fbk sel
Std encoder standard encoder input (default)
Exp encoder expanded encoder input, using option cards:
Command source for the selection of the encoder used for
Spd fbk sel src
speed feedback (factory setting: Int spd fbk sel)
Encoder type connected to the std input, it can be selected as:
digital single channel frequency input: channel A.
Frequency input
Signal +5V must be connected between A and power
supply common.
digital encoder (factory setting)
digital
sinusoidal encoder, select the correct jumper settings on the
sinusoidal
regulation card, RV33 - 1 (see section 1.6 in the Hardware Guide)
Encoder pulses per revolution (ppr) value of the standard input (factory setting =1024 ppr)
standard input. It can be:
frequency and period measuring.(factory setting)
FP
frequency measuring
F
The FP mode has a higher resolution (position can drift with a 0 reference),default value.
The F mode has lower resolution at high speeds, but is better at low speeds by varying
the drive's encoder scan rate. This provides low drift at 0 Reference.
Power supply voltage of the standard Encoder input.
It can be selected among 6.16, 5.91, 5.68, 5.41 V
to compensate long motor length cable (factory setting = 5.41 V)
Peak voltage value of the sinusoidal encoder connected to the
standard input. Range between 0.5V (default value) and 1.5V.
encoder type connected to the Exp input, it can be selected as:
digital encoder
Digital
digital single channel frequency input: channel A.
Frequency input
Signal +5V must be connected between A and power
supply common.
—————— Function Description ——————
6KCV301ENC
6KCV301D14A4F