Diameter Calculation (Diameter Calc) - GE AV-300i User Manual

The PID Output Block is shown in the figure below.
PID FF mon
PID PI out mon
PID PD out mon
PID output cfg
PID out sign
PID out gain
PID output mon
PID out mon
PID outS mon

1.15.7 Diameter Calculation (Diameter Calc)

This Function allows to perform a preliminary calculation of a coil diameter before starting the line. It allows to
avoid undesired mechanical sealings of the dancer.
The calculation is based on the moving of the dancer from the lower limit switch position to a central position as
compared to the winder angular moving during the initial phase.
The function is only available with a dancer reaction. The calculation result initializes the PI Block output.
Description:
APPL FUNCTION
APPL FUNCTION
Ch.1
152
GEH-6641E
X
-
+
Output selection: Monopolar/Bipolar
Scale factor (output gain)
Direct output displaying
Displaying of an output with a scale factor (gain setting)
PID
Diameter calc
Settings
Max deviation
Positioning spd
Gear box ratio
Dancer constant
Minimum diameter
DiaClc start src
Start ?
Press I key
Results
Diameter
Diacal PIO
DCDelta error
DCDelta pos
SAVE PARAMETERS
—————— Function Description ——————
X
PID out sign PID out gain
PID out mon
PID outS mon