Toro CM-658H-S Operator's Manual page 18

Hitching a Machine with a Pintle Hitch
Coupler
1. Remove the pin from the pintle hitch and open it
(Figure 24).
Figure 24
2. Position the ring on the tow pole onto the hook of the
pintle hitch (Figure 24).
3. Close the top of the pintle hitch and secure it with the
pin (Figure 24).
4. If the machine is equipped with a trailer-light kit,
connect the wire plug of the tow vehicle to the wire
plug of the machine.
Hitching a Machine with a Pin Hitch
Coupler
1. Position the front of the pin hitch coupler so that it
is located between the top and bottom plates of the
pin/clevis receiver hitch of the tow vehicle, and ensure
that the holes are aligned (Figure 25B).
A
C
1. Hitch pin
2. Hairpin cotter
G019809
2. Insert a 19 mm (3/4 inch) or 22 mm (7/8 inch) hitch
pin through the holes in the coupler and the receiver
hitch (Figure 25B).
3. Insert a hairpin cotter through the hole in the bottom
of the hitch pin (Figure 25C).
4. If the machine is equipped with a trailer-light kit,
connect the wire plug of the tow vehicle to the wire
plug of the machine.
18
B
1
2
3
4
D
Figure 25
3. Pin hitch coupler
4. Pin/clevis receiver hitch
G020084