Toro CM-658H-S Operator's Manual page 16

1 3
4 2
Raising the Stabilizer Legs (Models
68007 and 68008)
Models 68007 and 68008 have a front stabilizer leg and 2 rear
stabilizer legs.
Raise the stabilizer legs before towing the machine.
1. Adjust the machine so that there is no weight resting
on the rear stabilizer legs.
2. Pull the clevis pin out from one of the rear stabilizer
legs and the bracket (Figure 20).
3. Slide the stabilizer leg up in the bracket and align the
pin hole of the bracket with the lower hole in the
stabilizer leg (Figure 20).
4. Push the clevis pin through the hole in the bracket and
the stabilizer leg (Figure 20).
5. Repeat steps 1 through 4 for the other rear stabilizer
leg.
6. Lift upward on the tongue so that there is no weight
resting on the front stabilizer leg.
Figure 19
Figure 20
7. Pull the clevis pin out from the front stabilizer leg and
the tongue (Figure 21).
G021 107
1. Remove the clevis pin.
2. Rotate the stabilizer leg
up.
8. Rotate the front stabilizer leg up into the tongue
(Figure 21).
9. Push the clevis pin through the rearward hole in the
tongue and the front stabilizer leg (Figure 21).
Hitching a Machine with a Stamped Ball
Coupler
1. Apply chassis grease to the socket of the coupler and
the area of the clamp that contacts the ball.
2. Oil the pivot points and sliding surfaces of the coupler
with SAE 30 motor oil.
3. Open the coupler latch (Figure 22).
G019917
16
3
2
1
G019915
Figure 21
3. Install the clevis pin.