Storage; Storing The Machine - Toro CM-658H-S Operator's Manual

Storage

Storing the Machine

For storage over 30 days, prepare the machine as follows:
1. Remove dirt and grime from the external parts of the
entire machine, especially the engine. Clean dirt and
debris from the outside of the engine cylinder-head
fins and blower housing.
Important: You can wash the machine with mild
detergent and water.
2. Condition the fuel system as follows:
A. Add a petroleum-based stabilizer/conditioner to
fuel in the tank. Follow the mixing instructions
from the stabilizer manufacturer. Do not use an
alcohol-based stabilizer (ethanol or methanol).
Important: Do not store
stabilizer/conditioned fuel over 90 days.
Note: Fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and used at
all times.
B. Run the engine for 5 minutes to distribute the
conditioned fuel through the fuel system.
C. Stop the engine, allow it to cool, and drain the
fuel tank using a pump-type siphon. Dispose of
fuel properly; recycle it according to local codes.
D. Start the engine and run it until it stops.
E. Choke the engine.
F. Start and run the engine until it will not start again.
3. Clean the sediment cup; refer to Cleaning the Sediment
Cup (page 34).
4. Service the air cleaner; refer to Servicing the Air
Cleaner (page 29).
5. Change the engine crankcase oil; refer to Changing the
Engine Oil (page 30).
6. Remove the spark plug and check the condition; refer
to Servicing the Spark Plug (page 31).
7. Condition the engine as follows:
A. Remove the spark plug and pour 2 tablespoons
of engine oil into the spark-plug hole; refer to
Servicing the Spark Plug (page 31).
B. Pull the recoil-start handle slowly to crank the
engine and distribute the oil inside the cylinder.
C. Install the spark plug; refer to Servicing the Spark
Plug (page 31).
Note: Do not install the wire on the spark plug.
8. Grease the machine; refer to Lubricating the Machine
(page 29).
9. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
10. Paint all scratched or bare metal surfaces with paint
available from your Authorized Toro Dealer.
11. Store the machine in a clean, dry garage or storage area.
12. Cover the machine to protect it and keep it clean.
37