Toro CM-658H-S Operator's Manual page 17

A
B
2
1
C
1. Bail
4. Position the coupler on top of the hitch ball (Figure
22A).
5. Close the coupler latch (Figure 22B).
6. Open the bail on the safety pin, and insert the pin
through the hole in the latch (Figure 22B).
7. Rotate the free end of the bail over the end of the safety
pin that is protruding through the latch (Figure 22C).
8. If the machine is equipped with a trailer-light kit,
connect the wire plug of the tow vehicle to the wire
plug of the machine.
Hitching a Machine with a Forged Ball
Coupler
1. Apply removable thread-locking compound to the
threads of the coupler bolt to prevent the coupler
handle from coming loose (Figure 23).
G020359
Figure 22
2. Safety pin
Important: Apply thread-locking compound as
needed in the future.
A
C
1. Coupler handle
2. Coupler
3. Clamp
2. Apply chassis grease to the socket of the coupler and
the area of the clamp that contacts the ball.
3. Push the coupler bolt up through the coupler clamp
and the coupler top, and connect the coupler handle
to the bolt (Figure 23A).
4. Position the coupler so that the socket is on top of the
hitch ball and the clamp is under the ball (Figure 23C).
5. Turn the coupler handle clockwise to thread it onto the
bolt until it is secure (Figure 23D).
Note: Use a wrench to keep the bolt from spinning.
6. If the machine is equipped with a trailer-light kit,
connect the wire plug of the tow vehicle to the wire
plug of the machine.
17
B
1
2
3
4
D
Figure 23
4. Bolt
5. Hitch ball
5
G019807