Checking The Engine Oil Level - Toro CM-658H-S Operator's Manual

Figure 33
1. Maximum fuel level
4. Install the fuel cap securely (Figure 32).
5. Wipe up any fuel that may have spilled.

Checking the Engine Oil Level

Service Interval: Before each use or daily
Important: Use 4-cycle engine oil that meets or exceeds
the requirements for API service category SJ, SL, SM,
or higher .
Crankcase Capacity: 1.1 L (1.2 US qt)
Important: If the oil level in the crankcase is too low
or too high and you run the engine, you may damage
the engine. This type of damage is not covered by the
warranty.
Note: Use SAE 10W-30 for general use. You can use
the other viscosities shown in the chart when the average
temperature in your area is within the indicated range (Figure
34).
1
G020679
5W - 30 / 10W - 30
0 20 40
-20 -10 0
1. Place the machine on a flat, level surface, and stop the
engine.
2. Allow the engine to cool.
3. Clean around the dipstick.
4. Remove the dipstick and wipe the end clean (Figure 35).
1
2
1. Fill port
2. Dipstick
5. Slide the dipstick fully into the fill port without
threading it into the port (Figure 35).
6. Remove the dipstick and look at the end. If the engine
oil level is low, slowly pour only enough oil into the fill
port to raise the level to the Full mark on the dipstick
(Figure 35).
Note: Toro Premium Engine Oil is available from
your Authorized Toro Dealer.
7. Replace and secure the dipstick (Figure 35).
23
30
60 80 100 F
10 20 30 40 C
Figure 34
3
4
Figure 35
3. Oil-level upper limit
4. Oil-level lower limit
o
o
g013375
G019746