Removing And Installing The Divider Plate - Toro CM-658H-S Operator's Manual

Removing and Installing the
Divider Plate
You need to remove the divider plate to provide access before
performing some maintenance procedures.
Removing the Divider Plate
1. Unlatch and open the cowl; refer to Opening the Cowl
(page 21).
2. Use a wrench to remove the 4 bolts that secure the
divider plate to the front cowl.
Note: Keep the bolts and washers for installing the
divider plate.
3. To remove the divider plate, lift it upward and tilt it
back so that it clears various engine components.
Installing the Divider Plate
1. Guide the divider plate into position against the front
cowl.
Note: Start with the divider plate tilted slightly back,
and then tilt it forward while lowering it into position.
2. Align the bolt holes in the divider plate and the front
cowl.
3. Install each of the 4 bolts, and hand-tighten them to
prevent cross-threading.
Figure 40
G021
Figure 41
4. Tighten the bolts with a wrench until they are secure.
G021094
102
28