Setting-Up The Machine For Operation - Toro ProPass 200 Operator's Manual

Setting-up the Machine for
Operation
The machine features a unique color-coded operation system that takes the guess-work out of setting up your machine. Simply
choose the spread, identify the color, and then adjust each setting to match that color to get a perfect spread every time.
Choosing the Spread
Choose the spread by reading the main operation decal found on the tailgate of the machine
1. Light spread spinner adjustment settings.
2. Heavy spread spinner adjustment settings.
This decal shows the range of spreads available and classifies them by color
rate of application from Ultra-Light through Ultra-Heavy. The spread density is indicated by the shaded ovals (light through
heavy). The approximate width is also indicated
Checking the Blades
Note: The machine is shipped with the spinner blades in
P B.
OSITION
The lighter spreads (blue panel) remind you to ensure that the
spinner blades are in P
OSITION
When the blades are in P
(closest to the center of the disc) are tight to the blade
wall and the outside bolts (closest to the edge of the
disc) are away from the blade wall.
This is critical as this position is engineered to give the
optimum spread and distribution at high speeds and low sand
volume.
For heavier settings (gold panel) the blades should be in
P B to provide the best distribution at higher volumes
OSITION
and slower disc speeds (Figure
A (Figure 30).
Figure 30
A, the inside bolts
OSITION
31).
Figure 28
3. Warning—slide adjustment and tailgate adjustment.
Figure 29
(Figure
When the blades are in P
(closest to the center of the disc) are away from the
blade wall and the outside bolts (closest to the edge of
the disc) are tight to the blade wall.
Important: Incorrect blade position is one of the main
reasons spread patterns fail.
19
(Figure 28).
29). Each color represents a different
Figure 31
B, the inside bolts
OSITION