Operating The Hydraulic Controls And Options - Toro ProPass 200 Operator's Manual

7. Lower the jack stand(s) as follows:
•
On tow-behind chassis, turn the jack stand 90
degrees (clockwise) to the down position to
support the machine
•
On Truckster direct connect chassis, move the jack
stands to the front of the machine and turn them
90 degrees until the bottom of both jack stands
points to the ground.
8. Lift the machine with the jack stand(s) until the weight
is off the tow-vehicle draw bar. Pull out the hitch pin.
9. Ensure that there is no further connection between the
machine and the tow vehicle.
Operating the Hydraulic
Controls and Options
Remote Control System
The remote control system consists of a handheld remote, a
+12 to +14.4 VDC Base Unit, and a wiring harness.
Button Functions
Button Name Primary Function
O /O Power the remote on and off.
N FF
A S Provides functional control on both the Floor and Option including on/off and
LL TART
displaying the speed.
F S Provides functional control of the hopper conveyor floor belt including on/off
LOOR TART
and displaying the floor speed.
F S Stops the Floor.
LOOR TOP
F D Decreases the Floor speed.
LOOR EC
23
Handheld Remote
Figure 42
1. LCD display
2. Remote status LED
3. All Start: Starts Floor and
Option
4. On/Off
5. Store: Saves Preset
Settings
6. Preset 1
7. Preset 2
8. Preset 3
9. All Stop: Stops all
functions
10. Floor Start
11. Floor Stop
12. Decrease Floor Speed
13. Increase Floor Speed
14. Option Start
15. Option Stop
16. Increase Option Speed
17. Decrease Option Speed