Toro ProPass 200 Operator's Manual page 14

Model 44751
1. Power harness
Model 44701
1. Power harness
6
Connecting the On/Off
Pendant
Model 44701 Only
Parts needed for this procedure:
1 On/Off Pendant
Procedure
Plug the On/Off pendant connector into the connector on
the machine (Figure 17).
Figure 15
2. Intermediate wire harness
Figure 16
2. Intermediate wire harness
1. On/Off pendant
7
Assembling the Handheld
Remote
Model 44751 Only
Parts needed for this procedure:
1 Handheld remote
4 AA batteries
1 Magnetic bracket
6
Screws, small
Procedure
1. Remove the rubber bands securing the remote halves
together, and remove the back cover.
2. Install the batteries into the terminal cradle observing
proper polarity. (If the batteries are improperly
installed, the unit will not be damaged, but it will fail
to operate.) The cradle is embossed with polarity
markings for each terminal
14
Figure 17
(Figure 18).