Maintenance; Recommended Maintenance Schedule(S) - Toro TX 1000 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.
Important: Refer to your engine owner's manual for additional maintenance procedures.
CAUTION
If you leave the key in the key switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the key switch and disconnect the wires from the spark plugs before you do any
maintenance. Set the wires aside so that they do not accidentally contact the spark plugs.
WARNING
Failure to properly maintain the machine could result in premature failure of machine systems, causing
possible harm to you or bystanders.
Keep the machine well maintained and in good working order as indicated in these instructions.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 50 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Maintenance Procedure
• Replace the hydraulic filter.
• Change the engine oil and filter.
• Check and adjust the track tension.
• Grease the machine. (Grease immediately after every washing.)
• Check the air-filter-service indicator.
• Check the engine-oil level.
• Drain water and other contaminants from the fuel filter/water separator.
• Clean the tracks.
• Check the tracks for excessive wear and proper tension.
• Clean the screen, oil cooler, and front of the radiator (more often in dirty or dusty
conditions).
• Check the coolant level in the expansion tank.
• Test the parking brake.
• Remove debris from the machine.
• Check for loose fasteners.
• Remove the air-cleaner cover, clean out debris, and check the air-filter-service
indicator.
• Check the hydraulic-fluid level.
• Check the battery condition.
• Change the engine oil. (Service more frequently if conditions are extremely dusty
or sandy.)
• Check and adjust the track tension.
• Check the cooling system hoses.
• Check the alternator/fan belt tension (refer to the engine owner's manual for
instructions).
• Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mounting
supports, wear, weather, and chemical deterioration.
• Check for dirt buildup in the chassis.
• Change the oil filter. (Service more frequently if conditions are extremely dusty
or sandy.)
• Replace the hydraulic filter.
25