Toro Dingo TX 413 Setup Instructions

Trailer
Dingo TX 413 Compact Utility Loader
Model No. 22999
Note: Determine left and right sides of the machine from
the normal operating position.
Setup
Install attachment holder to the base trailer by sliding the
post on the attachment holder into the pocket on the trailer
(Fig. 1).
Figure 1
1. Base trailer
2. Pocket
The components used in the following procedures are
shipped loose with the trailer.
1. Locate the attachment holder and set screws. Set screws
may be installed if not shipped loose.
3
2
1
3. License plate mount
Original Instructions (EN)
2. Place the attachment holder post into the trailer pocket
as shown in Figure 2.
Figure 2
1. Attachment holder post
3. Tighten the two set screws in the pocket to secure the
attachment holder to the trailer (Fig. 2).
4. Remove the bolt and nut fastened to the pin on the
trailer hinge (Fig. 3).
5. Line up the ramp hinges with the posts welded to the
trailer hinges and install the ramp by mating the posts
and hinges (Fig. 3).
5
6
Figure 3
1. Ramp
2. Trailer bed
3. Bolt
Form No. 3351-919
Setup Instructions
1
2
2. Set screw
1
3
4
2
4. Nut
5. Ramp hinge
6. Trailer hinge post