Toro TX 1000 Operator's Manual page 32

4. Engage the parking brake, shut off the engine, and
remove the key.
5. Drain the oil beneath the platform
CAUTION
Components will be hot if the machine has
been running. If you touch hot components,
you may be burned.
Use care to avoid touching hot components
while changing the oil and/or filter.
Figure 47
6. Remove the oil-fill cap and slowly pour approximately
80% of the specified amount of oil in through the
valve cover.
7. Check the oil level.
8. Slowly add additional oil to bring the level to the upper
hole on the dipstick.
9. Replace the fill cap.
Changing the Oil Filter
(Figure 47).
g031212
g029385
10. Replace the fill cap.
11. Install the front cover; refer to
32
1. Raise the loader arms and secure with the cylinder
locks; refer to Installing the Cylinder Locks (page
2. Engage the parking brake, shut off the engine, and
remove the key.
3. Remove the front cover; refer to
Cover (page 28).
4. Drain the oil from the engine; refer to
Engine Oil (page 31).
5. Place a shallow pan or rag under the filter to catch oil.
6. Change the oil filter (Figure
Figure 48
7. Remove the oil-fill cap and slowly pour approximately
80% of the specified amount of oil in through the
valve cover.
8. Check the oil level.
9. Slowly add additional oil to bring the level to the upper
hole on the dipstick.
Cover (page 28).
26).
Removing the Front
Changing the
48).
g029749
Removing the Front