Checking The Hydraulic-Fluid Level - Toro TX 1000 Operator's Manual

Checking the
Hydraulic-Fluid Level
Service Interval: Every 25 hours
Hydraulic-Tank Capacity: 37.9 L (10 US gallons)
Refer to Hydraulic Fluid Specifications (page 44)
hydraulic-fluid specifications.
Important: Always use the correct hydraulic fluid.
Unspecified fluids will damage the hydraulic system.
1. Remove any attachments.
2. Park the machine on a level surface.
3. Raise the loader arms and install the cylinder locks.
4. Shut off the engine and remove the key.
5. Open the hood and secure the prop rod.
6. Remove the right side screen.
7. Clean the area around the filler neck of the hydraulic
tank (Figure 64).
Figure 64
1. Filler-neck cap
8. Remove the filler-neck cap and check the fluid level
on the dipstick (Figure
Note: The fluid level should be between the 2 notches
of the dipstick while the arms are lowered or at the
lower notch while the arms are raised.
for
65).
1. Filler neck
9. If the level is low, add enough fluid to raise it to the
proper level.
10. Install the filler-neck cap.
11. Install the side screen.
12. Close the hood.
13. Remove and store the cylinder locks and lower the
loader arms.
g029748
45
Figure 65
2. Dipstick
g029729