Table of Contents
Advertisement
Using Stabilizer/Conditioner
Use fuel stabilizer/conditioner in the machine to keep
the fuel fresh longer when used as directed by the
fuel-stabilizer manufacturer.
Important:
Do not use fuel additives containing
methanol or ethanol.
Add the amount of fuel stabilizer/conditioner to fresh
fuel as directed by the fuel-stabilizer manufacturer.
Filling the Fuel Tank(s)
1.
Park the machine on a level surface, engage
the parking brake (if equipped), and lower the
loader arms.
2.
Shut off the engine, remove the key, and allow
the engine to cool.
3.
Clean around the fuel-tank cap and remove it
(Figure
14).
Figure 14
1. Fuel-tank cap
4.
Add fuel to the tank until the level is 6 to 13 mm
(1/4 to 1/2 inch) below the bottom of the filler
neck.
Important:
This space in the tank allows
fuel to expand. Do not fill the fuel tank
completely full.
5.
Install the fuel-tank cap securely, turning it until
it clicks.
6.
Wipe up any spilled fuel.
Performing Daily
Maintenance
Before starting the machine each day, perform the
Each Use/Daily procedures listed in the
(page
24).
Important:
Check the hydraulic-fluid level before
starting the engine for the first time; refer to
Checking the Hydraulic-Fluid Level (page
During Operation
During Operation Safety
General Safety
•
Do not exceed the rated operating capacity, as the
machine may become unstable, which may result
in loss of control.
•
Do not carry a load with the arms raised. Always
carry loads close to the ground.
•
Use only Toro-approved attachments and
accessories. Attachments can change the stability
and the operating characteristics of the machine.
•
For machines with a platform:
– Lower the loader arms before stepping off the
platform.
– Do not try to stabilize the machine by putting
your foot on the ground. If you lose control of
the machine, step off the platform and away
from the machine.
g242641
– Do not place your feet under the platform.
– Do not move the machine unless you are
standing with both feet on the platform and your
hands are holding onto the reference bars.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Look behind and down before backing up to
ensure that the path is clear.
•
Never jerk the controls; use a steady motion.
•
The owner/user can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing including gloves, eye
protection, long pants, substantial slip-resistant
footwear, and hearing protection. Tie back long
hair and do not wear loose clothing or loose
jewelry.
•
Do not operate the machine when you are tired, ill,
or under the influence of alcohol or drugs.
16
Maintenance
46).
Advertisement
Table of Contents
