Hardware Wiring Of The Components - Siemens SINAMICS S120 Faq

SINAMICS S120 at Technology CPU Entry ID: 21767896
Smart line modules do not feature a DRIVE-CLiQ interface; for this reason,
port X100 at the CU320 control unit (as at the SINAMICS S120 training
case) is not used in this case.
1.4

Hardware wiring of the components

Since the smart line module does not feature a DRIVE-CLiQ interface for
connection to the CU320 control unit, it is required to connect the signals of
this module to the control unit via the hardware wiring.
The following signals are to be wired between the smart line module (SLM)
and the CU320 control unit; interfacing at the SINAMICS S120 training
case is performed via the TB30 terminal board:
Table 1-2 Hardware wiring between smart line module and control unit
Signal
SLM Ready
Overtemperature
Prewarning
Reset
Figure 1-2 Hardware wiring at the SINAMICS S120 training case
V1.0
Setup of the SINAMICS S120 Training Case
SLM
DO: X21.1
DO: X21.2
DI: X22.3
Ready
1
2
Pre Warning
3
4
Reset
5
-X21
...
-X481
TB30
-X22
CU 320
(6SL3040-0MA00-0AA1)
Smart line
module
(6SL3130-6AE15-0AA0)
(1FK7022-5AK71-1LG0)
Edition 10/28/05
TB30
DI: X481.1
DI: X481.3
DO: X481.5
1
2
3
4
1
2
3
4
Double
motor module
(6SL3120-2TE13-0AA0)
-X1 -X2
Motor
&
encoder
1
Motor
&
encoder
2
(1FK7022-5AK71-1AG3)
Requirements
Comment
SLM ready for
operation
Prewarning
overtemperature
Reset failures
SMC 20
(6SL3055-0AA00-5BA1)
-X520
7/58