Checking The Safety-Interlock System; After Operation Safety; Using The Hitch Lock - Toro GreensPro 1260 Greens Roller Operator's Manual

Checking the
Safety-Interlock System
CAUTION
If the safety-interlock switches are
disconnected or damaged, the machine could
operate unexpectedly, causing personal
injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily, and replace any damaged
switches before operating the machine.
Important:
If the safety-interlock system does not
operate as described below, have an Authorized
Toro Distributor repair it immediately.
1. Engage the parking brake, ensure that the
motion pedals are in the
start the engine.
2. Sit on the seat.
3. With the parking brake engaged, gently press a
motion pedal down; the engine should shut off
after approximately 1 second.
4. With the engine running and the brake
disengaged, stand up and verify that the engine
shuts off after 1 second.
Note:
The safety-interlock system is also designed
to shut off the engine if the operator rises off the seat
while the machine is moving.

After Operation Safety

•
Park the machine on a level surface; engage the
parking brake or chock the wheels as required;
shut off the engine; and wait for all movement to
stop before leaving the machine.
•
Clean grass and debris from the muffler and
engine compartment to help prevent fires. Clean
up oil or fuel spills.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Shut off the fuel before storing or transporting the
machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn, damaged, or missing decals.
position, and
NEUTRAL

Using the Hitch Lock

Connecting the Machine to the
Tow Vehicle
Push down on the hitch-lock lever while inserting the
hitch assembly onto the tow-vehicle hitch. Release
the lever when the hitch and the hitch assembly are
aligned (Figure 23).
Important:
Ensure that the lever returns to the Up
position and that the hitch and the hitch assembly
are engaged.
1. Hitch assembly (forward)
2. Hitch-lock lever (up)
Disconnecting the Machine from
the Tow Vehicle
Park the machine on level ground and chock the
wheels.
Push down on the hitch-lock lever while removing
the hitch assembly from the tow-vehicle hitch
23). Release the latch when the hitch and the hitch
assembly are disengaged.
19
Figure 23
3. Hitch assembly
(backward)
4. Hitch-lock lever (down)
g028434
(Figure