Toro GreensPro 1260 Greens Roller Operator's Manual page 32

Cleaning
Clean off the rollers as needed by spraying water
through the holes in the roller housings
Figure 38
1. Access holes
Ensure that the area around the hydraulic motor is
clean by removing any dirt and debris
Figure 39
1. Hydraulic motor
Storage
1.
(Figure 38).
2.
g036889
(Figure 39).
3.
4.
5.
g036788
32
Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the rollers and the engine. Clean dirt and chaff
from the outside of the cylinder-head fins and
the blower housing on the engine.
Important:
You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use of
water, especially near the engine.
For long-term storage (more than 90 days) add
stabilizer/conditioner additive to fuel in the tank.
A. Run the engine to distribute the conditioned
fuel through the fuel system for 5 minutes.
B. Either shut off the engine, allow it to cool,
and drain the fuel tank, or operate the
engine until it shuts off.
C. Start the engine and run it until it shuts off.
Repeat the procedure with the choke on
until the engine does not start again.
D. Dispose of fuel properly. Recycle it
according to local codes.
Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is worn or
damaged.
Paint all scratched or bare metal surfaces. Paint
is available from your authorized Toro distributor.
Store the machine in a clean, dry garage or
storage area. Cover the machine to protect it
and keep it clean.