Toro GreensPro 1260 Greens Roller Operator's Manual page 9

•
In the front holes, use a bolt (M10 x 100
mm), 2 washers (M10), and a locknut (M10).
•
In the rear holes, use a bolt (M12 x 100 mm),
2 washers (M12), and a locknut (M12).
•
If your machine has a third washer included
with each bolt, use those washers as spacers
between the hitch and the inside of the hitch
pivot bracket (Figure
Note:
Use the holes in the hitch pivot bracket to
match the hitch height of the tow-vehicle hitch.
Figure 5
1. Hitch
2. Hitch pivot bracket
3. Washer—M10 (2)
4. Bolt (M10)
6).
g025914
5. Washer—M12 (2)
6. Bolt (M12)
7. Locknut (M12)
8. Locknut (M10)
1. Spacer washers
3. Tighten the small bolt to 73 N∙m (54 ft-lb) and
the large bolt to 126 N∙m (93 ft-lb).
4. Push up on the hitch assembly until the latch
lever is unlocked from the slide detent
1. Latch lever
5. Pull the hitch down.
6. Step on the hitch pedal until the hitch locks into
place (Figure
9
Figure 6
Figure 7
8).
g025915
(Figure 7).
g024011