Network Device Connect Fail - Huawei ECC500 User Manual

ECC500
User Manual
Impact on the System
After this alarm is generated, prompt maintenance is required.
Possible Causes



Procedure
Step 1 Check whether the communications cable between the ECC500 and the device is
disconnected.


Step 2 Check whether the ECC500 communications board is faulty.


Step 3 Check whether the device is faulty.


----End

6.2.5 Network Device Connect Fail

Description
This alarm is generated when a networked device is disconnected from the ECC500.
Attribute
Alarm ID
-
Impact on the System
After this alarm is generated, the device keeps running but prompt maintenance is required.
Possible Causes



Issue 04 (2019-12-20)
The communications cable is disconnected.
The ECC500 communications board is faulty.
The device is faulty.
If yes, reconnect the communications cable.
If no, go to Step 2.
If yes, repair or replace the communications board.
If no, go to Step 3.
If yes, repair the device.
If no, contact Huawei technical support.
The communications cable is disconnected.
Parameters are incorrectly set for the networked device.
The network is unstable.
Copyright © Huawei Technologies Co., Ltd.
Alarm Severity
Warning
6 Maintenance and Troubleshooting
Alarm Type
Alarm
61