Replacing The Hydraulic Filter - Toro Sand Pro 3040 Operator's Manual

Figure 42
1. Hydraulic-reservoir cap
4. Remove the cap from the reservoir.
5. Remove the dipstick from the filler neck and
wipe it with a clean rag.
6. Insert the dipstick into the filler neck; then
remove it and check the level of the fluid
43).
When the reservoir is properly filled with
hydraulic fluid, you should see the fluid
level between the upper and lower marks
(necked-down area) on the dipstick.
Important:
If the fluid level is between the
upper and lower marks, no fluid addition is
required.
g002704
(Figure
1. Upper limit
7. If the fluid level is too low, slowly add the
specified hydraulic fluid to the reservoir until the
fluid level reaches the necked-down area on the
dipstick.
Important:
contamination, clean the surface of
the of hydraulic-fluid containers before
opening them. Ensure that the pour spout
and the funnel are clean.
Important:
hydraulic fluid.
8. Install the reservoir cap.
Replacing the Hydraulic
Filter
Service Interval: Every 1,000 hours—If you
Every 800 hours—If you are not using the
recommended hydraulic fluid or have ever
filled the reservoir with an alternative fluid,
replace the hydraulic filter.
1. Park the machine on a level surface, shut off the
engine, engage the parking brake, and remove
the key.
34
Figure 43
2. Lower limit
To prevent system
Do not overfill the reservoir with
are using the recommended
hydraulic fluid, replace the
hydraulic filter.
g035109