Fuel System Maintenance; Replacing The Fuel Filter - Toro Sand Pro 3040 Operator's Manual

Figure 27
Fuel System
Maintenance

Replacing the Fuel Filter

Service Interval: Every 500 hours
An in-line filter is incorporated into the fuel line. Use
the following procedures when replacement becomes
g002724
necessary:
1. Close the fuel-shutoff valve, loosen the hose
clamp on the carburetor side of the filter, and
remove the fuel line from the filter
1. Fuel filter
2. Place a drain pan under the filter, loosen the
remaining hose clamp, and remove the filter.
3. Install the new filter with the arrow on the filter
body pointing away from the fuel tank (toward
the carburetor).
4. Slide the hose clamps onto the ends of the fuel
lines.
5. Push the fuel lines onto the fuel filter and secure
them with the hose clamps.
Note:
Be sure that the arrow on the side of the
filter points toward the carburetor.
26
(Figure
Figure 28
2. Hose clamps
28).
g002729