Power Cabling - Samsung RF4402d-D1A Installation Manual

Radio access network
Table of Contents

Advertisement

Power Cabling

The power supply device consists of the following elements:
Figure 67. Power Equipment Elements
Commercial
AC Distributor
Power
Since power is applied to the system where the power cable is connected by
manipulating the circuit breaker of the rectifier, be sure to check the rectifier's
breaker is turned off (open) before connecting the power cable to the power
connector. If the system is installed while the circuit breaker is on, the worker may
be critically injured as soon as the cable is connected in the wrong way.
Handling the power cable incorrectly may damage the rack or cause an electric
short-circuit through the cable. Ensure the power switch on the rectifier or the
system is turned off before handling the power.
The fasteners for power cable must be tightly secured to prevent electrical
accidents.
The heat-resistant temperature of the power cable should be 90°C or more.
Install the power cable to the power port of the system by considering the radius of
curvature of its cable specification and then cut the cable. If operator installs the
cable after cutting, there may be length difference among the core wires at the end
of the cable because of cable curvature. This may result in poor contact after the
cable is connected to the power port.
When using the same DC power source with a device for outdoor, discuss with a
installation engineer of manufacturer to protect a CDU from a residual surge
energy.
When using a DC power cable, it is possible to use up to 10 m for 8 AWG.
However, the distance is under the condition that the cable is installed normally.
When the condition changes, the distance changes.
When using an AC power cable, it is possible to use up to 30 m for 12 AWG.
However, the distance is under the condition that the cable is installed normally.
When the condition changes, the distance changes.
Install a circuit breaker to a rectifier (or power distributor) for the stable power.
The capacity of circuit breaker is 40 A. (Use UL Listed circuit breakers.)
RF4402d Series Installation Manual v1.0
Copyright © 2018, All Rights Reserved.
Chapter 3 Connecting Cables
AC
DC
AC/DC Convertor
(or Site Rectifier)
Confidential
System
75

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rf4402d series

Table of Contents