Sector Antenna Installation - Samsung RF4402d-D1A Installation Manual

Sector Antenna Installation
The method of sector antenna installation is as follows.
Put up an antenna pole and insert the sector antenna into the antenna pole
1
using a fixing clamp.
Set the antenna's up/down tilt to 0° and fix the fixing clamps at the top and
2
bottom.
Adjust the tilted angle of the antenna by taking the signal strength into account.
3
The bolts on the upper and lower guide clamps must be loose as to allow angle
4
adjustment of the antenna.
After adjusting the antenna angle, tighten up the 4 loose bolts on the upper and
5
lower guide clamps.
Figure 104. Sector Antenna
Guide Clamp Bolt_3
Main Radiation Direction
Antenna Input Port
RF4402d Series Installation Manual v1.0
Copyright © 2018, All Rights Reserved.
Appendix B Sector Antenna Installation
Guide Clamp Bolt_1
Upper Fixing Clamp
Upper Guide Clamp
Guide Clamp Bolt_2
Pole
Lower Guide Clamp
Lower Fixing Clamp
Guide Clamp Bolt_4
Confidential
114