Installing The Cutting Units; Setting The Clip-Control Feature; Adding Rear Weight - Toro Greensmaster 3420 TriFlex Operator's Manual

7

Installing the Cutting Units

Parts needed for this procedure:
1 Gauge bar
Cutting unit (obtain from your authorized Toro
3
distributor)
3
Grass basket
3 Electric-reel-motor counterweight
6 Capscrew
3 O-ring
Procedure
1. Prepare the cutting units for installation; refer to
your cutting unit Operator's Manual.
2. Apply grease to the inside diameter of the drive
coupler.
3. Install an O-ring to each reel motor as shown
in Figure 9.
4. Install the electric-reel-motor counterweight;
refer to Installing the Electrical Counterweights
(page 49).
5. Install the cutting units; refer to
Cutting Units (page
Figure 9
Installing the
49).
8
Setting the Clip-Control
Feature
No Parts Required
Procedure
The machine has a clip-control feature that varies the
speed of the reels with the speed of the machine to
maintain a constant clip. This achieves a consistent,
high quality-of-cut and a uniform after-cut appearance.
The clip-control feature is off by default; to configure it
and turn it on, refer to
(page 21)
9

Adding Rear Weight

Parts needed for this procedure:
Weight Kit, Part No. 121-6665 (purchase separately)
1 Note: This kit is not required for units with the 3 wheel
drive kit installed.
Procedure
This unit complies with EN ISO 5395:2013 and ANSI
B71.4-2017 when equipped with Weight Kit, Part No.
121-6665.
Note:
If the unit is equipped with a 3-Wheel Drive
Kit, additional weight is not required to meet EN ISO
5395:2013 and ANSI B71.4-2017.
g256064
15

Setting the Clip-Control Feature