HP 3PAR StoreServ 7000 Service Manual page 63

3. Type 2 and press ENTER to Add a new InServ.
SP - InServ Configuration Manipulation
Enter Control-C at any time to abort this process
1 ==> Display InServ information
2 ==> Add a new InServ
3 ==> Modify an InServ config parameters
4 ==> Remove an InServ
X Return to the previous menu
2
4. Type the static IP address of the system (InServ) and press ENTER to add.
SP - InServ Configuration Manipulation
Enter Control-C at any time to abort this process
Please enter the IP address of the InServ you wish to add
-OR -
Enter QUIT to abort:
<static.ip.address>
NOTE: If adding a storage system fails, exit from the process and check the SP software
version for compatibility. Update the SP with the proper InForm OS version before adding
additional systems.
5. After successfully adding the system, press ENTER to return to the SP menu.
Adding <static.ip.address> to firewall rules on interface eth0
If you see any Password: prompts during this process
it is an indication that the nodes in the InServ
have NOT been properly configured!!
IF THIS IS THE CASE!
communicating with <static.ip.address> using base key...
base key ok
interrogating <static.ip.address> for version number...
Version 2.4.1.GA-x reported on <static.ip.address>
retrieving system data for <static.ip.address> ...
3PAR system name <InServ Name> found for <static.ip.address>
SYSID <InServ Name> found for <static.ip.address>
serial number <InServ serial #>found for <static.ip.address>
Writing configuration file for <static.ip.address>...
verifying / adding cli service ids...
attempting to force current keys onto node...
replaced key on node 0 of cluster <InServ Name>
replaced key on node 0 of cluster <InServ Name> in altroot
replaced key on node 1 of cluster <InServ Name>
replaced key on node 1 of cluster <InServ Name> in altroot
Adding InServ to NTP configuration...
DO NOT CONTINUE
Contact 3PAR technical support!
Adding a Storage System to the Service Processor 63