HP 3PAR StoreServ 7000 Service Manual page 60

a. Select a country from the list by choosing the corresponding number, then press ENTER.
b. Select a continent or ocean by choosing the corresponding number, then press ENTER.
c. Select a country from the regions list, type the corresponding number, then press ENTER.
d. Select a time zone region from the list, type the corresponding number, then press ENTER.
18. Verify the time zone setting is correct, type 1 and press ENTER. Choosing option 2 restarts the
time zone configuration.
NOTE:
the screen for appending the command to make the time zone change permanent.
19. Press ENTER to accept the default date in brackets, or type the current date in MM/DD/YYYY
format and press ENTER.
20. Press ENTER to accept the default time indicated by the installation script, or type the current
time in HH:MM format.
21. Type yes and press ENTER to verify the date you indicated in step 19.
22. Select the default SSH site keys.
Using the DEFAULT, installed Site key files:
Do you wish to use the DEFAULT, installed Site key files?
(y or n)
y
CAUTION:
system have not been properly configured. Verify the IP addresses on the SP and controller
nodes. Use the red crossover cable to connect the highest node port ETH 0 to SP ETH 0 to
establish a private network.
23. Press ENTER to conclude Service Processor Setup Wizard configuration.
InServ configuration is no longer done during the Moment Of Birth.
Use spmaint after a successful MOB to do that configuration.
Press ENTER to continue. [ENTER]
NOTE:
must first be installed in order to communicate and add a storage system. To install OS files,
see "Installing HP 3PAR OS Files " (page
60 Installing Storage Software Manually
The system makes the time zone change permanent. Disregard the instructions on
If this is the INITIAL INSTALLATION of this 3PAR SP
and InServ at this site, the DEFAULT keys should be used.
If this is a REPLACEMENT SP, or there is already an InServ
running at this site with which this SP must communicate,
do one of the following:
1) If you have external media containing the currently
deployed key pair (on CD or floppy), then answer NO
and provide the Keys to use.
2) If you do not have a copy of the current keys,
answer YES and force a key-exchange by MANUALLY
adding the cluster during the SP Moment of Birth,
or by using "spmaint" option 6.4.2 AFTER the moment
of birth to invoke (or force) a key exchange.
You may have to manually add any existing InServ
clusters in order to perform the key exchange.
If you receive any Password: prompts during this process, the nodes in the
After completing the Service Processor Setup Wizard process, additional OS files
61).