HP 3PAR StoreServ 7000 Service Manual page 59

SOCKS4
SOCKS5
-OR-
quit to abort setting a proxy
SOCKS5
Please enter the port to contact on the proxy system [1080]
-OR-
quit to abort setting a proxy
14. Type the IP address of your NTP system (if applicable). If an NTP system is not required, press
ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Enter the IP address of an external NTP system [none]
15. Type yes to configure the SP firewall in permissive mode.
SP Network Parameters
Enter Control-C at any time to abort this process
The SP firewall protects the SP and the customer
network from unauthorized use.
configured in permissive mode to allow
any host to connect to the SP via SSH and HTTP.
Do you wish to configure the SP firewall
in permissive mode?
yes
16. Press ENTER or type yes and press ENTER to verify the network information you have supplied.
SP Network Parameters
Enter Control-C at any time to abort this process
The Host Name is: <spname>
- Public IP address: <static.IP.address>
- Netmask: <subnet.mask.address>
- Gateway: <default.gateway.address>
PERMISSIVE FIREWALL MODE SELECTED
NTP system address:
Data Transfer media: ETHERNET
Remote Operations not allowed
Connection Portal: 3PAR default portal
Is this data correct? (yes or no)? [yes]
yes
NOTE: Answering no here returns you to step 6.
17. Set up the time zone for the operating site as follows:
It can be
[yes/NO]
Manually Setting up the Service Processor 59